No, I’m not dead ! Time flies since my last post but I’m back with what many people asked: the smoothieboard’s config file for my laser setup.
Be careful with this config file, minded for metric operation, but this shouldn’t be a problem because it’s the worldwide measurement unit 🙂
Here is the complete file but for the old firmware (edge-19b1b4d, Nov 15 2015)
Config file for Smoothieboard + K40 + LightObject
Here are the most important parameters:
alpha_steps_per_mm 157.89 # Steps per mm for alpha stepper beta_steps_per_mm 157.89 # Steps per mm for beta stepper gamma_steps_per_mm 3169 # Steps per mm for gamma stepper
Alpha and Beta are for X and Y, gamma is for LightObject’s Z-table.